Velocity Washer is a patented technology designed to eliminate galling and give you 30x faster disassembly. With over 100 million hours in use, Velocity Washer increases production and reduces labor costs by eliminating galled and seized nuts that cause production delays during disassembly.
Velocity Washer is installed just like a normal washer. To install, simply place the Velocity Washer on the stud. Due to its symmetric design, it can’t be installed in the wrong orientation, delivering the simplest installation. You then torque the nut on using standard breakout procedures: there are no special tools required. Just put them on and go.
For breakout, all you need to do is turn the nut 12 degrees to the left. The Velocity Washer will pop and all load will be removed, allowing the nut to easily run off – and giving you a breakout that’s 30x faster than ever before.
Velocity Washer enhances worker safety by eliminating hot bolting (AKA single stud changeout), torches, and unnecessary time on tools.
Patented – US Patent #8,579,572 and several other worldwide patents.
Talk to our experts today to find out how the Velocity Washer can make your outages shorter, your workers safer, and your plant more productive.
Testimonials
“We have the Velocity Washers on two of our blowdown exchangers. We typically have to torch cut these large studs; with the Velocity Washers they spun off just like shown on the promotional videos. We re-used the studs and nuts.”
“The same reactor head after installation of Velocity Washers, took only 1-2 hours in total to disassemble, with no damage to capital equipment, no hot work needed and no studs needed replacing.”
“Our results with the Velocity Washers were very good. Normally we would budget four 10 hour shifts of gouging. This involved a substantial hoarding and of course time. With the Velocity Washers it took us a bit over half a shift.”
Velocity Washer Gallery
Get A Quote Today
One of our experts will be in touch within 24 hours to provide a free quote and advice.